Safety Data Sheets / Technovit 9100 MMA Embedding Kit - Liquid New

Safety Data Sheet

Technovit 9100 MMA Embedding Kit - Liquid New

Version 1Last reviewed 27 November 2024Catalogue: 14655 (L), EMS14655

1. Identification

Product Identifiers

Product Name: Technovit 9100 MMA Embedding Kit - Liquid New
Other Names: Technovit 9100 Liquid New
Product Number(s): 14655 (L), EMS14655
CAS Number: Not available.

Recommended use of the chemical and restriction on use

Laboratory chemicals.

Company Details

ProSciTech Pty Ltd
11 Carlton Street
KIRWAN QLD 4817
Australia
(07) 4773 9444
pst@proscitech.com
proscitech.com.au

Emergency Contact Details

ProSciTech Pty Ltd
11 Carlton Street
KIRWAN QLD 4817
Australia
(07) 4773 9444
pst@proscitech.com
proscitech.com.au

2. Hazards Identification

Classification of the substance or mixture

GHS02 Flame
Flam. Liq. 2 H225 Highly flammable liquid and vapour.
GHS07
Skin Irrit. 2 H315 Causes skin irritation.
Skin Sens. 1 H317 May cause an allergic skin reaction.
STOT SE 3 H335 May cause respiratory irritation.

Label Elements

Signal Words: None
Hazard Statement(s): Hazard-determining components of labelling: Methyl Methacrylate
Highly flammable liquid and vapour.
Causes skin irritation.
May cause an allergic skin reaction.
May cause respiratory irritation.
Precautionary Statement(s): Keep away from heat/sparks/open flames/hot surfaces. No smoking.
Ground/bond container and receiving equipment.
Use explosion-proof electrical/ventilating/lighting equipment.
Use only non-sparking tools.
Take precautionary measures against static discharge.
Avoid breathing dust/fume/gas/mist/vapours/spray.
Wash thoroughly after handling.
Use only outdoors or in a well-ventilated area.
Contaminated work clothing should not be allowed out of the workplace.
Wear protective gloves/protective clothing/eye protection/face protection.

Primary route(s) of entry

Not available.

Human Health

Inhalation: Remove victim to fresh air and keep at rest in a position comfortable for breathing. Call a POISON CENTER/doctor if you feel unwell.
Ingestion: No further relevant information available.
Eyes: No further relevant information available.
Skin: (or hair) Remove/take off immediately all contaminated clothing. Rinse skin with water/shower. Take off contaminated clothing and wash it before reuse. If skin irritation or rash occurs: Get medical advice/attention.

Environment

In case of fire: Use CO₂, powder or water spray for extinction.
Store in a well-ventilated place. Keep container tightly closed.
Store in a well-ventilated place. Keep cool.
Store locked up.
Dispose of contents/container in accordance with local/regional/national/international regulations.

3. Composition / Information on Ingredients

Name	CAS No.	Content (w/w)	Classification
Methyl Methacrylate	80-62-6	>50-≤100%	Not Available

4. First Aid Measures

Ingestion: If symptoms persist consult doctor.
Inhalation: Supply fresh air and to be sure call for a doctor.
In case of unconsciousness place patient stably in side position for transportation.
Skin Contact: Immediately wash with water and soap and rinse thoroughly.
Eye Contact: Rinse opened eye for several minutes under running water.
Other Information: No further relevant information available.

5. Firefighting Measures

Suitable extinguishing equipment

Fire: CO₂, sand, extinguishing powder. Do not use water.
HAZCHEM: For safety reasons unsuitable extinguishing agents: Water with full jet.

Special protective equipment and precautions for fire fighters

No special measures required.

6. Accidental Release Measures

Personal precautions, protective equipment and emergency procedures: Wear protective equipment. Keep unprotected persons away.
Environmental precautions: Do not allow to enter sewers/surface or ground water.
Methods and materials for containment and clean up: Absorb with liquid-binding material (sand, diatomite, acid binders, universal binders, sawdust).
Ensure adequate ventilation.
Do not flush with water or aqueous cleansing agents.

7. Handling and Storage

Precautions for safe handling: Ensure good ventilation/exhaustion at the workplace.
Prevent formation of aerosols.
Keep ignition sources away - Do not smoke.
Protect from heat.
Protect against electrostatic charges.
Conditions for safe storage: Store in a cool location.
Keep container tightly sealed.
Store in cool, dry conditions in well sealed receptacles.
Protect from heat and direct sunlight.

8. Exposure Controls / Personal Protection

Exposure Standards

Material	TWA ppm	TWA mg/m³	STEL ppm	STEL mg/m³
80-62-6 Methyl Methacrylate	50ppm	208mg/m³	100ppm	416mg/m³

Engineering controls: Keep away from foodstuffs, beverages and feed.
Immediately remove all soiled and contaminated clothing.
Wash hands before breaks and at the end of work.
Avoid contact with the skin.
Avoid contact with the eyes and skin.

Personal protective equipment

Eye and face protection: Tightly sealed goggles.
Skin protection: Protective gloves. The glove material has to be impermeable and resistant to the product/the substance/the preparation. Selection of the glove material on consideration of the penetration times, rates of diffusion and the degradation. The exact break through time has to be found out by the manufacturer of the protective gloves and has to be observed.
Body protection: Protective clothing.
Respiratory protection: In case of brief exposure or low pollution use respiratory filter device. In case of intensive or longer exposure use self-contained respiratory protective device.

9. Physical and Chemical Properties

General information

Appearance: Colourless fluid
Odour: Characteristic.
pH: Not determined.
Vapour Pressure: 47 hPa
Density: 0.94g/cm³
Boiling Point: 101°C
Melting Point: Undetermined
Solubility: Not miscible or difficult to mix.
Specific Gravity of Density: Not available.
Flash Point: 10°C
Flammable (Explosive) Limits: Lower: 2.1 Vol%
Upper: 12.5 Vol%
Ignition Temperature: 430°C
Formula: Not available.

10. Stability and Reactivity

Reactivity: No further relevant information available.
Chemical stability: No decomposition if used according to specifications.
Possibility of hazardous reactions: No dangerous reactions known.
Conditions to avoid: No further relevant information available.
Incompatible materials: No further relevant information available.

11. Toxicological Information

Acute effects: 80-62-6 Methyl Methacrylate
Oral LD50 7872 mg/kg (rat)
Eye contact: No irritating effect.
Skin contact: Irritant to skin and mucous membranes. Sensitisation possible through skin contact.
Ingestion: No further relevant information available.
Inhalation: No further relevant information available.
Toxicity and irritation: Irritant

12. Ecological Information

Ecotoxicity: No further relevant information available.
Persistence and degradability: No further relevant information available.
Bioaccumulative potential: No further relevant information available.
Other adverse effects: Water hazard class 1: slightly hazardous for water.
Do not allow undiluted product or large quantities of it to reach ground water, water course or sewage system.

13. Disposal Considerations

General information

Must not be disposed together with household garbage. Do not allow product to reach sewage system.
Disposal must be made according to official regulations.

14. Transport Information

ADG label required

HAZCHEM: For safety reasons unsuitable extinguishing agents: Water with full jet.
UN Number: UN1247
Proper shipping name: 1247 METHYL METHACRYLATE MONOMER, STABILIZED solution.
Transport hazard class: Class 3 Flammable liquids.
Packing group: II
Environmental hazard: Not applicable.
Special precautions for users: Warning: Flammable liquids.
Hazard identification number (Kemler code): 33
EMS Number: F-E,S-D
Stowage Category: C
Stowage Code:
SW1 Protected from sources of heat.
SW2 Clear of living quarters.
Additional information: Limited quantities (LQ) 1L
Excepted quantities (EQ) Code: E2
Maximum net quantity per inner packaging: 30mL
Maximum net quantity per outer packaging: 500mL
Transport category: 2
Tunnel restriction code: D/E

15. Regulatory Information

Poisons Schedule Number: S6, S10
Other Information: A Chemical Safety Assessment has not been carried out.

16. Other Information

SDS preparation date: 27 November 2024
Comments: This information is based on our present knowledge. However, this shall not constitute a guarantee for any specific product features and shall not establish a legally valid contractual relationship.