Safety Data Sheets / Glutaraldehyde/Paraformaldehyde, 0.1M Phosphate Buffered - 2%/1%
Safety Data Sheet
Glutaraldehyde/Paraformaldehyde, 0.1M Phosphate Buffered - 2%/1%
1. Identification
Product Identifiers
- Product Name
- Glutaraldehyde/Paraformaldehyde, 0.1M Phosphate Buffered - 2%/1%
- Other Names
- Paraformaldehyde 1% Glutaraldehyde 2% in 0.1M Phosphate buffer
- Product Number(s)
- 15949-30, 15949-35, CEMS15949-30, CEMS15949-35
- CAS Number
- Not available
Recommended use of the chemical and restriction on use
Laboratory chemicals
Company Details
ProSciTech Pty Ltd
11 Carlton Street
KIRWAN QLD 4817
Australia
(07) 4773 9444
pst@proscitech.com
proscitech.com.au
11 Carlton Street
KIRWAN QLD 4817
Australia
(07) 4773 9444
pst@proscitech.com
proscitech.com.au
Emergency Contact Details
ProSciTech Pty Ltd
11 Carlton Street
KIRWAN QLD 4817
Australia
(07) 4773 9444
pst@proscitech.com
proscitech.com.au
11 Carlton Street
KIRWAN QLD 4817
Australia
(07) 4773 9444
pst@proscitech.com
proscitech.com.au
2. Hazards Identification
Classification of the substance or mixture
- GHS08 Health hazard
- Resp. Sens. 1 H334 May cause allergy or asthma symptoms or breathing difficulties if inhaled.
- Muta. 2 H341 Suspected of causing genetic defects.
- Carc. 1B H350 May cause cancer.
- GHS07
- Skin Irrit. 2 H315 Causes skin irritation.
- Eye Irrit. 2A H319 Causes serious eye irritation.
- Skin Sens. 1 H317 May cause an allergic skin reaction.
- STOT SE 3 H335 May cause respiratory irritation.
Label Elements


- Signal Words
- None
- Hazard Statement(s)
- Causes skin irritation.
- Causes serious eye irritation.
- May cause allergy or asthma symptoms or breathing difficulties if inhaled.
- May cause an allergic skin reaction.
- Suspected of causing genetic defects.
- May cause cancer.
- May cause respiratory irritation.
- Precautionary Statement(s)
- Obtain special instructions before use.
- Do not handle until all safety precautions have been read and understood.
- Avoid breathing dust/fume/gas/mist/vapours/spray.
- Wash thoroughly after handling.
- Use only outdoors or in a well-ventilated area.
- Contaminated work clothing should not be allowed out of the workplace.
- Wear protective gloves/protective clothing/eye protection/face protection.
- Wear respiratory protection.
Primary route(s) of entry
Not available
Human Health
- Inhalation
- Remove victim to fresh air and keep at rest in a position comfortable for breathing. If experiencing respiratory symptoms call a POISON CENTER/Doctor.
- Ingestion
- Not available
- Eyes
- Rinse cautiously with water for several minutes. Remove contact lenses, if present and easy to do. Continue rinsing. If eye irritation persists get medical advice/attention.
- Skin
- Wash with plenty of water. Take off contaminated clothing and wash it before reuse. If skin irritation or rash occurs get medical advice/attention.
Environment
- Store in a well-ventilated place. Keep container tightly closed.
- Store locked up.
- Dispose of contents/container in accordance with local/regional/national/international regulations.
3. Composition / Information on Ingredients
| Name | CAS No. | Content (w/w) | Classification |
|---|---|---|---|
| Glutaraldehyde | 111-30-8 | ≤2.5% | Mixtures |
| Formaldehyde | 50-00-0 | ≤2.5% | Mixtures |
4. First Aid Measures
- Ingestion
- If symptoms persist consult a doctor.
- Inhalation
- Supply fresh air and to be sure call for a doctor.
- In case of unconsciousness place patient in side position for transportation.
- Skin Contact
- Immediately wash with water and soap and rinse thoroughly.
- Eye Contact
- Rinse opened eye for several minutes under running water. If symptoms persist, consult a doctor.
- Other Information
- Symptoms of poisoning may even occur after several hours; therefore medical observation for at least 48 hours after the accident.
5. Firefighting Measures
Suitable extinguishing equipment
- Fire
- Use fire extinguishing methods suitable to surrounding conditions.
- HAZCHEM
- No further relevant information available.
Special protective equipment and precautions for fire fighters
Mouth respiratory protective device.
6. Accidental Release Measures
- Personal precautions, protective equipment and emergency procedures
- Not required.
- Environmental precautions
- Inform respective authorities in case of seepage into water course or sewage system.
- Do not allow to enter sewers/surface or ground water.
- Methods and materials for containment and clean up
- Absorb with liquid-binding material (sand, diatomite, acid binders, universal binders, sawdust).
- Dispose contaminated material as waste according to item 13.
- Ensure adequate ventilation.
7. Handling and Storage
- Precautions for safe handling
- Ensure good ventilation/exhaustion at the workplace.
- Open and handle receptacle with care.
- Prevent formation of aerosols.
- Keep respiratory protective device available.
- Conditions for safe storage
- Keep container tightly sealed.
8. Exposure Controls / Personal Protection
Exposure Standards
| Material | TWA ppm | TWA mg/m³ | STEL ppm | STEL mg/m³ |
|---|---|---|---|---|
| Glutaraldehyde | 0.1ppm | 0.41mg/m³ | ||
| Formaldehyde | 1ppm | 1.2mg/m³ | 2ppm | 2.5mg/m³ |
- Engineering controls
- Keep away from foodstuffs, beverages and feed.
- Immediately remove all soiled and contaminated clothing.
- Wash hands before breaks and at the end of work.
- Store protective clothing separately.
- Avoid contact with the eyes and skin.
Personal protective equipment
- Eye and face protection
- Tightly sealed goggles.
- Skin protection
- Wear protective gloves. The glove material has to be impermeable and resistant to the product/the substance/the preparation. Selection of the glove material on consideration of the penetration times, rates of diffusion and the degradation. The exact break through time has to be found out by the manufacturer or the protective gloves and has to be observed.
- Body protection
- Not available
- Respiratory protection
- In case of brief exposure or low pollution use respiratory filter device. In case of intensive or longer exposure use self-contained respiratory protective device.
9. Physical and Chemical Properties
General information
- Appearance
- Clear liquid
- Odour
- Fruit-like
- pH
- Not determined
- Vapour Pressure
- 23hPa at 20°C
- Density
- 1 g/cm³ at 20°C
- Boiling Point
- 100°C
- Melting Point
- 0°C
- Solubility
- Not miscible or difficult to mix.
- Specific Gravity of Density
- Not available
- Flash Point
- Not applicable
- Flammable (Explosive) Limits
- Not determined
- Ignition Temperature
- Product is not selfigniting.
- Formula
- Not available
10. Stability and Reactivity
- Reactivity
- No further relevant information available.
- Chemical stability
- No decomposition if used according to specifications.
- Possibility of hazardous reactions
- No dangerous reactions known.
- Conditions to avoid
- No further relevant information available.
- Incompatible materials
- No further relevant information available.
11. Toxicological Information
- Acute effects
- Not available.
- Eye contact
- Irritating effect.
- Skin contact
- Irritant to skin and mucous membranes.
- Ingestion
- Not available.
- Inhalation
- Sensitisation possible through inhalation.
- Sensitisation possible through skin contact.
- Toxicity and irritation
- Harmful
- Irritant
- Carcinogenic
12. Ecological Information
- Ecotoxicity
- No further relevant information available.
- Persistence and degradability
- No further relevant information available.
- Bioaccumulative potential
- No further relevant information available.
- Other adverse effects
- Harmful to fish.
- Water hazard class 2: hazardous for water.
- Do not allow product to reach ground water, water course or sewage system.
- Danger to drinking water if even small quantities leak into the ground.
- Harmful to aquatic organisms.
13. Disposal Considerations
General information
- Must not be disposed together with household garbage. Do not allow product to reach sewage system.
- Disposal must be made according to official regulations.
14. Transport Information
ADG label required
- HAZCHEM
- No further relevant information available.
- UN Number
- Not regulated
- Proper shipping name
- Not regulated
- Transport hazard class
- Not regulated
- Packing group
- Not regulated
- Environmental hazard
- Not applicable
- Special precautions for users
- Not applicable
- Additional information
- Not applicable
15. Regulatory Information
- Poisons Schedule Number
- Glutaraldehyde S2, S5, S6
- Formaldehyde S2, S6, S10
- Other Information
- Workers are not allowed to be exposed to the hazardous carcinogenic materials contained in this preparation.
- Exceptions can be made by the authorities in certain cases.
16. Other Information
- SDS preparation date
- 24 February 2026
- Comments
- This information is based on our present knowledge. However, this shall not constitute a guarantee for any specific product features and shall not establish a legally valid contractual relationship.
