Safety Data Sheets / FIRM Dye - Acrylic Resin Sections

Safety Data Sheet

FIRM Dye - Acrylic Resin Sections

Version 1Last reviewed 19 February 2026Catalogue: EMS12780-05; 12780-05

1. Identification

Product Identifiers

Product Name: Cresyl Fast Violet Fluorescent (FIRM) Dye - Acrylic Resin Sections
Other Names: Cresyl fast violet fluorescent dye
Product Number(s): EMS12780-05; 12780-05
CAS Number: -

Recommended use of the chemical and restriction on use

Laboratory use

Company Details

ProSciTech Pty Ltd
11 Carlton Street
KIRWAN QLD 4817
Australia
(07) 4773 9444
pst@proscitech.com
proscitech.com.au

Emergency Contact Details

ProSciTech Pty Ltd
11 Carlton Street
KIRWAN QLD 4817
Australia
(07) 4773 9444
pst@proscitech.com
proscitech.com.au

2. Hazards Identification

Classification of the substance or mixture

GHS02 Flame
Flammable Liquids 2 H225 Highly flammable liquid and vapour
GHS08 Health hazard
Carcinogenicity 1A H350 May cause cancer.

Label Elements

Signal Words: None
Hazard Statement(s): H225 Highly flammable liquid and vapour
H351 Suspected of causing cancer
Precautionary Statement(s): P201 Obtain special instructions before use.
P202 Do not handle until all safety precautions have been read and understood.
P210 Keep away from heat, hot surface, sparks, open flames and other ignition sources. - No smoking.
P233 Keep container tightly closed.
P240 Ground/bond container and receiving equipment.
P241 Use explosion-proof [electrical/ventilating/lighting/.../] equipment.
P242 Use only non-sparking tools.
P243 Take precautionary measures against static discharge.
P280 Wear protective gloves/protective clothing/eye protection/face protection.
P303±P361±P353 IF ON SKIN (or hair): Take off Immediately all contaminated clothing. Rinse SKIN with water [or shower].
P308±P311 IF exposed or concerned: Call a POISON CENTER/doctor/...
P370±P378 In case of fire: Use CO₂, sand, extinguishing powder. Do not use water to extinguish.
P403 Store in a well-ventilated place.
P404 Store in a closed container.
P405 Store locked up.
P501 Dispose of contents/container in accordance with local/regional/national/international regulations.

Primary route(s) of entry

Inhalation, ingestion

3. Composition / Information on Ingredients

Name	CAS No.	Content (w/w)	Classification
Ethyl alcohol	64-17-5	>50-≤100%	Mixture of the substances listed below with nonhazardous additions.

4. First Aid Measures

Ingestion: If symptoms persist consult doctor.
Inhalation: Supply fresh air; consult doctor in case of complaints
Skin Contact: Generally the product does not irritate the skin.
Eye Contact: Rinse opened eye for several minutes under running water.
Other Information: No further relevant information available.

5. Firefighting Measures

Suitable extinguishing equipment

Fire: CO₂, sand, extinguishing powder. DO NOT USE WATER.
HAZCHEM: No further relevant information available.

Special protective equipment and precautions for fire fighters

No further relevant information available.

6. Accidental Release Measures

Personal precautions, protective equipment and emergency procedures: Wear protective equipment. Keep unprotected persons away.
Environmental precautions: Do not allow to enter sewers/ surface or ground water.
Methods and materials for containment and clean up: Absorb with liquid-binding material (sand, diatomite, acid binders, universal binders, sawdust).
Ensure adequate ventilation.
Do not flush with water or aqueous cleansing agents

7. Handling and Storage

Precautions for safe handling: No special precautions are necessary if used correctly.
Conditions for safe storage: Store in a cool location.
Keep receptacle tightly sealed.
Keep ignition sources away - Do not smoke.
Protect against electrostatic charges.

8. Exposure Controls / Personal Protection

Exposure Standards

Material	TWA ppm	TWA mg/m³	STEL ppm	STEL mg/m³
64-17-5 Ethyl alcohol	1000 ppm	1900 mg/m³	1000ppm	-

Engineering controls: Wash hands before breaks and at the end of work

Personal protective equipment

Eye and face protection: Tightly sealed goggles
Skin protection: The glove material has to be impermeable and resistant to the product/ the substance/ the preparation.
Due to missing tests no recommendation to the glove material can be given for the product/ the preparation/ the chemical mixture.
Selection of the glove material on consideration of the penetration times, rates of diffusion and the degradation
Body protection: Not required
Respiratory protection: Not required

9. Physical and Chemical Properties

General information

Appearance: Liquid
Odour: Characteristic
pH: Not determined
Vapour Pressure: at 20 °C (68 °F): 59 hPa (44.3 mm Hg)
Density: Not determined
Boiling Point: 78 °C (172.4 °F)
Melting Point: Undetermined
Solubility: Not miscible or difficult to mix
Specific Gravity of Density: Not determined
Flash Point: 13 °C (55.4 °F)
Flammable (Explosive) Limits: Highly flammable - Product is not explosive. However, formation of explosive air/vapour mixtures are possible. Explosion limits:
Lower: 3.5 Vol %
Upper: 15 Vol %
Ignition Temperature: 425 °C (797 °F) - Product is not selfigniting
Formula: Solvent content:
Organic solvents: 70.0 %
VOC content: 70.00 %
700.0 g/l / 5.84 lb/gal

10. Stability and Reactivity

Reactivity: No further relevant information available
Chemical stability: No decomposition if used according to specifications.
Possibility of hazardous reactions: No dangerous reactions known
Conditions to avoid: No further relevant information available
Incompatible materials: No further relevant information available

11. Toxicological Information

Acute effects: No further relevant information available
Eye contact: No further relevant information available
Skin contact: No further relevant information available
Ingestion: No further relevant information available
Inhalation: No further relevant information available
Toxicity and irritation: No further relevant information available

12. Ecological Information

Ecotoxicity: No further relevant information available
Persistence and degradability: No further relevant information available
Bioaccumulative potential: No further relevant information available
Other adverse effects: No further relevant information available

13. Disposal Considerations

General information

Must not be disposed of together with household garbage.
Water hazard class 1 (Self-assessment): slightly hazardous for water
Do not allow undiluted product or large quantities of it to reach ground water, water course or sewage system.

14. Transport Information

ADG label required

HAZCHEM: No further relevant information available.
UN Number: UN1170
Proper shipping name: ETHANOL mixture
Transport hazard class: Class 3
Packing group: PG II
Environmental hazard: Not applicable
Special precautions for users: Warning: Flammable liquids
Additional information: Hazard identification number (Kemler code): 33
EMS Number: F-E,S-D
Stowage Category A
Limited quantities (LQ) 1L
Excepted quantities (EQ) Code: E2
Maximum net quantity per inner packaging: 30 mL
Maximum net quantity per outer packaging: 500 mL
UN 1170 ETHANOL (ETHYL ALCOHOL) MIXTURE, 3, II

15. Regulatory Information

Poisons Schedule Number: No further relevant information available.
Other Information: No further relevant information available.

16. Other Information

SDS preparation date: 19 February 2026
Comments: This information is based on our present knowledge. However, this shall not constitute a guarantee for any specific product features and shall not establish a legally valid contractual relationship.