Safety Data Sheets / Eukitt UV Mounting Medium
Safety Data Sheet
Eukitt UV Mounting Medium
1. Identification
Product Identifiers
- Product Name
- Eukitt UV Mounting Medium
- Other Names
- Not available
- Product Number(s)
- 15320-30, EMS15320-30
- CAS Number
- Not available.
Recommended use of the chemical and restriction on use
Laboratory chemicals.
Company Details
ProSciTech Pty Ltd
11 Carlton Street
KIRWAN QLD 4817
Australia
(07) 4773 9444
pst@proscitech.com
proscitech.com.au
11 Carlton Street
KIRWAN QLD 4817
Australia
(07) 4773 9444
pst@proscitech.com
proscitech.com.au
Emergency Contact Details
ProSciTech Pty Ltd
11 Carlton Street
KIRWAN QLD 4817
Australia
(07) 4773 9444
pst@proscitech.com
proscitech.com.au
11 Carlton Street
KIRWAN QLD 4817
Australia
(07) 4773 9444
pst@proscitech.com
proscitech.com.au
2. Hazards Identification
Classification of the substance or mixture
- GHS07
- Eye Irrit. 2A H319 Causes serious eye irritation
- Skin Sens. 1 H317 May cause an allergic skin reaction.
Label Elements

- Signal Words
- Warning
- Hazard Statement(s)
- Causes serious eye irritation.
- may cause an allergic skin reaction.
- Precautionary Statement(s)
- Avoid breathing dust/fumes/gas/mist/vapours/spray.
- Wear protective gloves/eye protection/ face protection.
- Wash thoroughly after handling.
- Contaminated work clothing should not be allowed out of the workplace.
Primary route(s) of entry
Not available.
Human Health
- Inhalation
- Not available
- Ingestion
- Not available
- Eyes
- Rinse cautiously with water for several minutes. Remove contact lenses, if present and easy to do. Continue rinsing. If eye irritation persists get medical advice/attention.
- Skin
- Wash with plenty of water. Wash contaminated clothing before reuse. If skin irritation or rash occurs get medical advice/attention.
Environment
Dispose of contents/container in accordance with local/regional/national/international regulations.
3. Composition / Information on Ingredients
| Name | CAS No. | Content (w/w) | Classification |
|---|---|---|---|
| 2-hydroxy-2-methylpropiophenone | 7473-98-5 | 2.5-10% | Mixture |
| 1,2-ethanediyl diacrylate | 2274-11-5 | ≤ 2.5% | Mixture |
4. First Aid Measures
- Ingestion
- If symptoms persist consult doctor.
- Inhalation
- Supply fresh air and to be sure call for a doctor. In case of unconsciousness place patient stably in side position for transportation.
- Skin Contact
- Immediately wash with water and soap and rinse thoroughly.
- Eye Contact
- Rinse opened eye for several minutes under running water. If symptoms persist, consult a doctor
- Other Information
- No further relevant information available.
5. Firefighting Measures
Suitable extinguishing equipment
- Fire
- Use fire extinguishing methods suitable to surrounding conditions.
- HAZCHEM
- No further relevant information available.
Special protective equipment and precautions for fire fighters
No special measures required.
6. Accidental Release Measures
- Personal precautions, protective equipment and emergency procedures
- Not required.
- Environmental precautions
- Do not allow to enter sewers/surface or ground water.
- Methods and materials for containment and clean up
- Absorb with liquid-binding material (sand, diatomite, acid binders, universal binders, sawdust). Ensure adequate ventilation.
7. Handling and Storage
- Precautions for safe handling
- Ensure good ventilation/exhaustion at the workplace. Prevent formation of aerosols.
- Conditions for safe storage
- Keep container tightly sealed.
8. Exposure Controls / Personal Protection
Exposure Standards
- Engineering controls
- Keep away from foodstuffs, beverages and feed.
- Immediately remove all soiled and contaminated clothing.
- Wash hands before breaks and at the end of work.
- Avoid contact with the eyes.
- Avoid contact with the eyes and skin.
Personal protective equipment
- Eye and face protection
- Tightly sealed goggles.
- Skin protection
- Wear protective gloves. The glove material has to be impermeable and resistant to the product/the substance/the preparation. Selection of the glove material on consideration of the penetration times, rates of diffusion and the degradation. The exact break through time has to be found out by the manufacturer of the protective gloves and has to be observed.
- Body protection
- Not available
- Respiratory protection
- In case of brief exposure or low pollution use respiratory filter device. In case of intensive or longer exposure use self-contained respiratory protective device.
9. Physical and Chemical Properties
General information
- Appearance
- Light yellow fluid
- Odour
- Ester-like
- pH
- Not determined
- Vapour Pressure
- Not determined
- Density
- 1.1 g/cm³ at 20°C
- Boiling Point
- >100°C
- Melting Point
- Undetermined
- Solubility
- Not miscible or difficult to mix.
- Specific Gravity of Density
- Not determined
- Flash Point
- >100°C
- Flammable (Explosive) Limits
- Not determined.
- Ignition Temperature
- Not determined
- Formula
- Not available
10. Stability and Reactivity
- Reactivity
- No further relevant information available.
- Chemical stability
- No decomposition if used according to specifications.
- Possibility of hazardous reactions
- No dangerous reactions known.
- Conditions to avoid
- No further relevant information available.
- Incompatible materials
- No further relevant information available.
11. Toxicological Information
- Acute effects
- Not available
- Eye contact
- Irritating effect.
- Skin contact
- No irritant effect.
- Ingestion
- Not available
- Inhalation
- Sensitisation possible through skin contact
- Toxicity and irritation
- Irritant
12. Ecological Information
- Ecotoxicity
- No further relevant information available.
- Persistence and degradability
- No further relevant information available.
- Bioaccumulative potential
- No further relevant information available.
- Other adverse effects
- Water hazard class 1: slightly hazardous for water. Do not allow undiluted product or large quatities to reach ground water, water course or sewage system.
13. Disposal Considerations
General information
Must not be disposed together with household garbage. Do not allow product to reach sewage system. Disposal must be made according to official regulations.
14. Transport Information
ADG label required
- HAZCHEM
- No further relevant information available.
- UN Number
- Not regulated
- Proper shipping name
- Not regulated
- Transport hazard class
- Not regulated
- Packing group
- Nota regulated
- Environmental hazard
- Not applicable.
- Special precautions for users
- Not applicable.
- Additional information
- Not applicable.
15. Regulatory Information
- Poisons Schedule Number
- None of the ingredients is listed.
16. Other Information
- SDS preparation date
- 23 February 2026
- Comments
- This information is based on our present knowledge. However, this shall not constitute a guarantee for any specific product features and shall not establish a legally valid contractual relationship.
