Safety Data Sheets / Eukitt Neo Xylene Free Mounting Medium
Safety Data Sheet
Eukitt Neo Xylene Free Mounting Medium
1. Identification
Product Identifiers
- Product Name
- Eukitt Neo Xylene Free Mounting Medium
- Other Names
- Not available
- Product Number(s)
- 15320-20, 15322-20, EMS15320-20, EMS15322-20
- CAS Number
- Not available
Recommended use of the chemical and restriction on use
- Laboratory chemicals
- Mounting medium
Company Details
ProSciTech Pty Ltd
11 Carlton Street
KIRWAN QLD 4817
Australia
(07) 4773 9444
pst@proscitech.com
proscitech.com.au
11 Carlton Street
KIRWAN QLD 4817
Australia
(07) 4773 9444
pst@proscitech.com
proscitech.com.au
Emergency Contact Details
ProSciTech Pty Ltd
11 Carlton Street
KIRWAN QLD 4817
Australia
(07) 4773 9444
pst@proscitech.com
proscitech.com.au
11 Carlton Street
KIRWAN QLD 4817
Australia
(07) 4773 9444
pst@proscitech.com
proscitech.com.au
2. Hazards Identification
Classification of the substance or mixture
- GHS08 Health hazard
- Carcinogenicity 2 H351 Suspected of causing cancer.
- Aspiration hazard 1 H304 May be fatal if swallowed and enters airways.
- GHS07
- Skin Irrit. 2 H315 Causes skin irritation.
- Skin Sens. 1 H317 May cause an allergic skin reaction
Label Elements


- Signal Words
- None
- Hazard Statement(s)
- Causes skin irritation.
- May cause an allergic skin reaction.
- Suspected of causing cancer.
- May be fatal if swallowed and enters airways.
- Precautionary Statement(s)
- Obtain special instructions before use.
- Do not handle until all safety precautions have been read and understood.
- Avoid breathing dust/fume/gas/mist/vapours/spray
- Wash thoroughly after handling.
- Contaminated work clothing must not be allowed out of the workplace.
- Wear protective gloves/protective clothing/eye protection/face protection/hearing protection
Primary route(s) of entry
Not available
Human Health
- Inhalation
- Not available
- Ingestion
- Immediately call a poison center/doctor. Do NOT induce vomiting
- Eyes
- Not available
- Skin
- If on skin: Wash with plenty of water.
- IF exposed or concerned: Get medical advice/attention.
- Take off contaminated clothing and wash it before reuse.
- If skin irritation or rash occurs: Get medical advice/attention.
Environment
- Store locked up.
- Dispose of contents/container in accordance with local/regional/national/international regulations.
3. Composition / Information on Ingredients
| Name | CAS No. | Content (w/w) | Classification |
|---|---|---|---|
| ®-p-mentha-1,8-diene | 5989-27-5 | 60-80% | Mixture |
| Methyl Methacrylate | 80-62-6 | 0.1-1% | Mixture |
| N-BUTYL METHACRYLATE, MONOMER | 0.1-1% | Mixture |
4. First Aid Measures
- Ingestion
- If symptoms persist consult doctor.
- Inhalation
- Supply fresh air and to be sure call for a doctor.
- In case of unconsciousness place patient stably in side position for transportation
- Skin Contact
- Immediately wash with water and soap and rinse thoroughly.
- Eye Contact
- Rinse opened eye for several minutes under running water.
- Other Information
- No further relevant information available.
5. Firefighting Measures
Suitable extinguishing equipment
- Fire
- Use fire fighting measures that suit the environment.
- HAZCHEM
- No further relevant information available.
Special protective equipment and precautions for fire fighters
No special measures required
6. Accidental Release Measures
- Personal precautions, protective equipment and emergency procedures
- Not required.
- Environmental precautions
- Inform respective authorities in case of seepage into water course or sewage system.
- Dilute with plenty of water.
- Do not allow to enter sewers/ surface or ground water
- Methods and materials for containment and clean up
- Absorb with liquid-binding material (sand, diatomite, acid binders, universal binders, sawdust).
- Dispose contaminated material as waste according to section 13.
- Ensure adequate ventilation.
- Protective Action Criteria for Chemicals
- PAC-1:
- 5989-27-5 ®-p-mentha-1,8-diene 15 ppm
- 80-62-6 Methyl Methacrylate 17 ppm
- N-BUTYL METHACRYLATE, MONOMER 19 mg/m³
- PAC-2:
- 5989-27-5 ®-p-mentha-1,8-diene 67 ppm
- 80-62-6 Methyl Methacrylate 120 ppm
- N-BUTYL METHACRYLATE, MONOMER 210 mg/m³
- PAC-3:
- 5989-27-5 ®-p-mentha-1,8-diene 170 ppm
- 80-62-6 Methyl Methacrylate 570 ppm
- N-BUTYL METHACRYLATE, MONOMER 1,300 mg/m³
7. Handling and Storage
- Precautions for safe handling
- Ensure good ventilation/exhaustion at the workplace
- Prevent formation of aerosols.
- Conditions for safe storage
- Requirements to be met by storerooms and receptacles: No special requirements.
- Information about storage in one common storage facility: Not required.
- Further information about storage conditions: None.
- Specific end use(s) No further relevant information available.
8. Exposure Controls / Personal Protection
Exposure Standards
| Material | TWA ppm | TWA mg/m³ | STEL ppm | STEL mg/m³ |
|---|---|---|---|---|
| Methyl Methacrylate | 50ppm | 100 mg/m³ | 100ppm | 410mg/m³ |
- Engineering controls
- Keep away from foodstuffs, beverages and feed.
- Immediately remove all soiled and contaminated clothing.
- Wash hands before breaks and at the end of work.
- Avoid contact with the skin.
- Avoid contact with the eyes and skin.
Personal protective equipment
- Eye and face protection
- Goggles recommended during refilling.
- Skin protection
- rotective gloves
- The glove material has to be impermeable and resistant to the product/ the substance/ the preparation.
- Due to missing tests no recommendation to the glove material can be given for the product/ the preparation/ the chemical mixture.
- Selection of the glove material on consideration of the penetration times, rates of diffusion and the degradation.
- Material of gloves
- The selection of the suitable gloves does not only depend on the material, but also on further marks of quality and varies from manufacturer to manufacturer. As the product is a preparation of several substances, the resistance of
- the glove material can not be calculated in advance and has therefore to be checked prior to the application.
- Penetration time of glove material
- The exact break through time has to be found out by the manufacturer of the protective gloves and has to be observed.
- Body protection
- Not available
- Respiratory protection
- In case of brief exposure or low pollution use respiratory filter device. In case of intensive or longer exposure use respiratory protective device that is independent of circulating air.
9. Physical and Chemical Properties
General information
- Appearance
- Liquid coloured according to product specification.
- Odour
- Characteristic
- pH
- Mixture is non-polar/aprotic.
- Vapour Pressure
- 2.3hPa at 20°C
- Density
- 0.85078 g/cm³ (7.09976 lbs/gal)
- Boiling Point
- 173 °C (343.4 °F) at 20 °C (68 °F)
- Melting Point
- Undetermined
- Solubility
- Fully miscible
- Specific Gravity of Density
- Not available
- Flash Point
- Not applicable
- Flammable (Explosive) Limits
- Lower: 0.7 Vol%
- Upper: 6.1 Vol%
- Ignition Temperature
- 255°C
- Formula
- Not available
10. Stability and Reactivity
- Reactivity
- No further relevant information available.
- Chemical stability
- No decomposition if used according to specifications.
- Possibility of hazardous reactions
- No dangerous reactions known.
- Conditions to avoid
- No further relevant information available.
- Incompatible materials
- No further relevant information available.
11. Toxicological Information
- Acute effects
- LD/LC50 values that are relevant for classification:
- 5989-27-5 ®-p-mentha-1,8-diene
- Oral LD50 4,400 mg/kg (rat)
- Eye contact
- No irritating effect.
- Skin contact
- Irritant to skin and mucous membranes.
- Ingestion
- Not available.
- Inhalation
- Not available
- Toxicity and irritation
- Sensitization possible through skin contact
- The product shows the following dangers according to internally approved calculation methods for preparations:
- Irritant
12. Ecological Information
- Ecotoxicity
- No further relevant information available.
- Persistence and degradability
- No further relevant information available.
- Bioaccumulative potential
- No further relevant information available.
- Other adverse effects
- Very toxic for fish.
- Harmful to fish
- Water hazard class 2: hazardous for water.
- Do not allow product to reach ground water course, or sewage system.
- Danger to drinking water if even small quantities leak into the ground.
- Also poisonous for fish and plankton in water bodies.
- Very toxic for aquatic organisms.
13. Disposal Considerations
General information
- Recommendation:
- Must not be disposed of together with household garbage. Do not allow product to reach sewage system.
- Uncleaned packagings:
- Recommendation: Disposal must be made according to official regulations.
- Recommended cleansing agent: Water, if necessary with cleansing agents.
14. Transport Information
ADG label required


- HAZCHEM
- No further relevant information available.
- UN Number
- UN2052
- Proper shipping name
- UN proper shipping name
- DOT Dipentene
- ADR 2052 DIPENTENE, ENVIRONMENTALLY HAZARDOUS
- IMDG DIPENTENE, MARINE POLLUTANT
- IATA DIPENTENE
- Transport hazard class
- Class 3 flammable liquids
- Label 9
- Packing group
- III
- Environmental hazard
- Environmental hazards: Product contains environmentally hazardous substances: ®-pmentha-1,8-diene
- Marine pollutant: Yes (DOT)
- Symbol (fish and tree)
- Special marking (ADR): Symbol (fish and tree)
- Special precautions for users
- Special precautions for user Warning: Flammable liquids
- Hazard identification number (Kemler code): 90
- EMS Number: F-E,S-E
- Stowage Category A
- Additional information
- Transport/Additional information:
- DOT
- Quantity limitations On passenger aircraft/rail: No limit
- On cargo aircraft only: No limit
- Remarks: Special marking with the symbol (fish and tree).
- ADR
- Excepted quantities (EQ) Code: E1
- Maximum net quantity per inner packaging: 30 mL
- Maximum net quantity per outer packaging: 1000 mL
- IMDG
- Limited quantities (LQ) 5L
- Excepted quantities (EQ) Code: E1
- Maximum net quantity per inner packaging: 30 mL
- Maximum net quantity per outer packaging: 1000 ml
15. Regulatory Information
- Poisons Schedule Number
- Sara
- Section 355 (extremely hazardous substances):
- None of the ingredients is listed.
- Section 313 (Specific toxic chemical listings):
- 80-62-6 Methyl Methacrylate
- · TSCA (Toxic Substances Control Act):
- All components have the value ACTIVE.
- · Hazardous Air Pollutants
- 80-62-6 Methyl Methacrylate
- Proposition 65
- · Chemicals known to cause cancer:
- None of the ingredients is listed.
- · Chemicals known to cause reproductive toxicity for females:
- None of the ingredients is listed.
- · Chemicals known to cause reproductive toxicity for males:
- None of the ingredients is listed.
- · Chemicals known to cause developmental toxicity:
- None of the ingredients is listed.
- · Carcinogenic categories
- · EPA (Environmental Protection Agency)
- 80-62-6 Methyl Methacrylate E, NL
- · TLV (Threshold Limit Value)
- 80-62-6 Methyl Methacrylate A4
- NIOSH-Ca (National Institute for Occupational Safety and Health)
- None of the ingredients is listed.
- Other Information
- The product is classified and labeled according to the Globally Harmonized System (GHS).
16. Other Information
- SDS preparation date
- 11 December 2025
- Comments
- Abbreviations and acronyms:
- ADR: Accord relatif au transport international des marchandises dangereuses par route (European Agreement Concerning the International
- Carriage of Dangerous Goods by Road)
- IMDG: International Maritime Code for Dangerous Goods
- DOT: US Department of Transportation
- IATA: International Air Transport Association
- EINECS: European Inventory of Existing Commercial Chemical Substances
- ELINCS: European List of Notified Chemical Substances
- CAS: Chemical Abstracts Service (division of the American Chemical Society)
- NFPA: National Fire Protection Association (USA)
- HMIS: Hazardous Materials Identification System (USA)
- VOC: Volatile Organic Compounds (USA, EU)
- LC50: Lethal concentration, 50 percent
- LD50: Lethal dose, 50 percent
- PBT: Persistent, Bioaccumulative and Toxic
- vPvB: very Persistent and very Bioaccumulative
- NIOSH: National Institute for Occupational Safety
- OSHA: Occupational Safety Health
- TLV: Threshold Limit Value
- PEL: Permissible Exposure Limit
- REL: Recommended Exposure Limit
- Skin irritation 2: Skin corrosion/irritation - Category 2
- Sensitization - skin 1: Skin sensitisation - Category 1
- Carcinogenicity 2: Carcinogenicity - Category 2
- Aspiration hazard 1: Aspiration hazard - Category 1
- References
- EMS SDS EUKITT Neo Xylene Free Mounting Medium 04/11/2022 https://www.emsdiasum.com/docs/technical/msds/15320-20.pdf
