Safety Data Sheets / Dimethylaminoethanol (DMAE)
Safety Data Sheet
Dimethylaminoethanol (DMAE)
1. Identification
Product Identifiers
- Product Name
- Dimethylaminoethanol (DMAE)
- Other Names
- 2-Dimethylaminoethanol
- Product Number(s)
- 13300, C050
- CAS Number
- 108-01-0
Recommended use of the chemical and restriction on use
Laboratory use, chemicals. Epoxy accelerator for Spurr's embedding kit.
Company Details
ProSciTech Pty Ltd
11 Carlton Street
KIRWAN QLD 4817
Australia
(07) 4773 9444
pst@proscitech.com
proscitech.com.au
11 Carlton Street
KIRWAN QLD 4817
Australia
(07) 4773 9444
pst@proscitech.com
proscitech.com.au
Emergency Contact Details
ProSciTech Pty Ltd
11 Carlton Street
KIRWAN QLD 4817
Australia
(07) 4773 9444
pst@proscitech.com
proscitech.com.au
11 Carlton Street
KIRWAN QLD 4817
Australia
(07) 4773 9444
pst@proscitech.com
proscitech.com.au
2. Hazards Identification
Classification of the substance or mixture
- GHS02 Flame
- Flam. Liq. 3 H226 Flammable liquid and vapour.
- GHS05 Corrosion
- Skin Corr. 1B H314 Causes severe skin burns and eye damage.
- GHS07
- Acute Tox. 4 H302 Harmful if swallowed.
- Acute Tox. 4 H312 Harmful in contact with skin.
- Acute Tox. 4 H332 Harmful if inhaled.
Label Elements



- Signal Words
- None
- Hazard Statement(s)
- Hazard-determining components of labelling:
- 2-dimethylaminoethanol
- Flammable liquid and vapour.
- Harmful if swallowed, in contact with skin or if inhaled.
- Causes severe skin burns and eye damage.
- Precautionary Statement(s)
- Keep away from heat/sparks/open flames/hot surfaces. No smoking.
- Keep container tightly closed.
- Ground/bond container and receiving equipment.
- Use explosion-proof electrical/ventilating/lighting equipment.
- Use only non-sparking tools.
- Take precautionary measures against static discharge.
- Do not breathe dusts or mists.
- Wash thoroughly after handling.
- Do not eat, drink or smoke when using this product.
- Use only outdoors or in a well-ventilated area.
- Wear protective gloves/protective clothing/eye protection/face protection.
Primary route(s) of entry
Not available.
Human Health
- Inhalation
- Remove victim to fresh air and keep at rest in a position comfortable for breathing.
- Ingestion
- Call a POISON CENTER/doctor if you feel unwell. Rinse mouth. Do NOT induce vomiting.
- Eyes
- Rinse cautiously with water for several minutes. Remove contact lenses, if present and easy to do. Continue rinsing. Immediately call a POISON/CENTER/doctor.
- Skin
- (or hair) Remove/take off immediately all contaminated clothing. Rinse skin with water/shower. Take off contaminated clothing and wash it before reuse. Wash contaminated clothing before reuse.
Environment
- In case of fire: Use CO₂, powder or water spray for extinction.
- Store in a well-ventilated place. Keep cool.
- Store locked up.
- Dispose of contents/container in accordance with local/regional/national/international regulations.
3. Composition / Information on Ingredients
| Name | CAS No. | Content (w/w) | Classification |
|---|---|---|---|
| 2-dimethylaminoethanol | 108-01-0 | <= 100 % | Flam. Liq. 3; Acute Tox. 4; Acute Tox. 3; Acute Tox. 4; Skin Corr./Irrit. 1B; Eye Dam./Irrit. 1; STOT SE 3; H226, H302, H331, H312, H314, H318, H335Concentration limits: >= 5 %: STOT SE 3, H335; |
4. First Aid Measures
- Ingestion
- Immediately call a doctor. Drink copious amounts of water and provide fresh air. Immediately call a doctor.
- Inhalation
- Supply fresh air. If required, provide artificial respiration. Keep patient warm. Consult doctor if symptoms persist. In case of unconsciousness place patient stably in side position for transportation.
- Skin Contact
- Immediately wash with water and soap and rinse thoroughly.
- Eye Contact
- Rinse opened eye for several minutes under running water. Then consult a doctor.
- Other Information
- Immediately remove any clothing soiled by the product. Symptoms of poisoning may even occur after several hours; therefore medical observation for at least 48 hours after the accident.
5. Firefighting Measures
Suitable extinguishing equipment
- Fire
- CO₂, extinguishing powder or water spray. Fight larger fires with water spray or alcohol resistant foam.
- Large Fire
- CO₂, extinguishing powder or water spray. Fight larger fires with water spray or alcohol resistant foam.
- HAZCHEM
- No further relevant information available.
Special protective equipment and precautions for fire fighters
Mouth respiratory protective device.
6. Accidental Release Measures
- Personal precautions, protective equipment and emergency procedures
- Wear protective equipment. Keep unprotected persons away.
- Environmental precautions
- Dilute with plenty of water.
- Do not allow to enter sewers/ surface or ground water.
- Methods and materials for containment and clean up
- Absorb with liquid-binding material (sand, diatomite, acid binders, universal binders, sawdust).
- Use neutralizing agent.
- Dispose contaminated material as waste according to item 13.
- Ensure adequate ventilation.
7. Handling and Storage
- Precautions for safe handling
- Ensure good ventilation/exhaustion at the workplace.
- Prevent formation of aerosols.
- Keep ignition sources away - Do not smoke.
- Protect from heat.
- Protect against electrostatic charges.
- Conditions for safe storage
- Keep receptacle tightly sealed.
- Store in cool, dry conditions in well sealed receptacles.
- Protect from heat and direct sunlight.
8. Exposure Controls / Personal Protection
Exposure Standards
| Material | TWA ppm | TWA mg/m³ | STEL ppm | STEL mg/m³ |
|---|---|---|---|---|
| 2-dimethylaminoethanol | 2ppm | 7.4mg/m³ | 6ppm | 22mg/m³ |
- Engineering controls
- Keep away from foodstuffs, beverages and feed.
- Immediately remove all soiled and contaminated clothing.
- Wash hands before breaks and at the end of work.
- Avoid contact with the eyes and skin.
Personal protective equipment
- Eye and face protection
- Tightly sealed goggles. Avoid contact with the eyes.
- Skin protection
- Wear protective gloves. The glove material has to be impermeable and resistant to the product/ the substance/ the preparation. Due to missing tests no recommendation to the glove material can be given for the product/ the preparation/ the chemical mixture. Selection of the glove material on consideration times, rates of diffusion and the degradation. The exact break through time has to be found out by the manufacturer of the protective gloves and has to be observed.
- Body protection
- Avoid contact with the skin. Wear appropriate clothing. Immediately remove all soiled and contaminated clothing.
- Respiratory protection
- In case of brief exposure or low pollution use respiratory filter device. In case of intensive or longer exposure use respiratory protective device that is independent of circulating air.
9. Physical and Chemical Properties
General information
- Appearance
- Fluid, colourless
- Odour
- Ammonia-like
- pH
- Not determined.
- Vapour Pressure
- 5.6 hPa (4 mm Hg) at 20°C
- Density
- 0.89 g/cm³ (7.427 lbs/gal) at 20°C
- Boiling Point
- 133°C
- Melting Point
- <-70°C
- Solubility
- Fully miscible
- Specific Gravity of Density
- Not determined.
- Flash Point
- 31°C
- Flammable (Explosive) Limits
- Not flammable
- Ignition Temperature
- 220°C
- Formula
- C-H??NO
- <strong data-start="123" data-end="145">Structure summary:<br data-start="145" data-end="148">HO-CH₂-CH₂-N(CH?)₂
10. Stability and Reactivity
- Reactivity
- No further relevant information available.
- Chemical stability
- No further relevant information available.
- Possibility of hazardous reactions
- No further relevant information available.
- Conditions to avoid
- No decomposition if used according to specifications.
- Incompatible materials
- No further relevant information available.
11. Toxicological Information
- Acute effects
- No further relevant information available.
- Eye contact
- Strong caustic effect.
- Skin contact
- Strong caustic effect on skin and mucous membranes.
- Ingestion
- Swallowing will lead to a strong caustic effect on mouth and throat and to the danger of perforation of esophagus and stomach.
- Inhalation
- No sensitising effects known.
- Toxicity and irritation
- LD/LC50 values that are relevant for classification:
- 108-01-0 2-dimethylaminoethanol
- Oral LD50 2000 mg/kg (rat)
- Dermal LD50 1370 mg/kg (rabbit)
- Inhalative LC50/4 h 3.25 mg/l (mouse)
12. Ecological Information
- Ecotoxicity
- Water hazard class 1 (Assessment by list): slightly hazardous for water
- Do not allow undiluted product or large quantities of it to reach ground water, water course or sewage system.
- Must not reach bodies of water or drainage ditch undiluted or unneutralized.
- Persistence and degradability
- No further relevant information available.
- Bioaccumulative potential
- No further relevant information available.
- Other adverse effects
- No further relevant information available.
13. Disposal Considerations
General information
- This material and its container must be disposed of as hazardous waste.
- Must not be disposed of together with household garbage. Do not allow product to reach sewage system.
- Disposal must be made according to official regulations.
14. Transport Information
ADG label required


- HAZCHEM
- No further relevant information available.
- UN Number
- UN2051
- Proper shipping name
- 2-Dimethylaminoethanol
- Transport hazard class
- 8 Corrosive substances
- Packing group
- PG II
- Environmental hazard
- Not known as a marine pollutant.
- Special precautions for users
- Warning: Corrosive substances
- Additional information
- Danger code (Kemler): 83
- DOT
- Quantity limitations On passenger aircraft/rail: 1 L
- On cargo aircraft only: 30 L
- ADR
- Excepted quantities (EQ) Code: E2
- Maximum net quantity per inner packaging: 30 mL
- Maximum net quantity per outer packaging: 500 mL
- IMDG
- Limited quantities (LQ) 1L
- Excepted quantities (EQ) Code: E2
- Maximum net quantity per inner packaging: 30 mL
- Maximum net quantity per outer packaging: 500 mL
- UN "Model Regulation":
- UN2051, 2-Dimethylaminoethanol, 8 (3), II
15. Regulatory Information
- Poisons Schedule Number
- S4
- Other Information
- No further relevant information available.
16. Other Information
- SDS preparation date
- 23 February 2026
- Comments
- This information is based on our present knowledge. However, this shall not constitute a guarantee for any specific product features and shall not establish a legally valid contractual relationship.
- References
- EMS SDS DMAE Dimethylaminoethanol 04/04/2025 https://www.emsdiasum.com/docs/technical/msds/13300.pdf
- Sigma-Aldrich SDS 2-Dimethylaminoethanol 26/10/2023 https://www.sigmaaldrich.com/AU/en/sds/aldrich/471453
