Safety Data Sheets / Citifluor CFM-3 Antifadent Solution
Safety Data Sheet
Citifluor CFM-3 Antifadent Solution
1. Identification
Product Identifiers
- Product Name
- Citifluor CFM-3 Antifadent Solution
- Other Names
- Not available.
- Product Number(s)
- 17979-20, 17979-30, ICFM3-10, ICFM3-25
- CAS Number
- Not available.
Recommended use of the chemical and restriction on use
Laboratory chemicals
Company Details
ProSciTech Pty Ltd
11 Carlton Street
KIRWAN QLD 4817
Australia
(07) 4773 9444
pst@proscitech.com
proscitech.com.au
11 Carlton Street
KIRWAN QLD 4817
Australia
(07) 4773 9444
pst@proscitech.com
proscitech.com.au
Emergency Contact Details
ProSciTech Pty Ltd
11 Carlton Street
KIRWAN QLD 4817
Australia
(07) 4773 9444
pst@proscitech.com
proscitech.com.au
11 Carlton Street
KIRWAN QLD 4817
Australia
(07) 4773 9444
pst@proscitech.com
proscitech.com.au
2. Hazards Identification
Classification of the substance or mixture
- GHS06 Skull and crossbones
- Acutte Tox. 3 H311 Toxic in contact with skin
- GHS07
- Skin Sens. 1 H317 May cause an allergic skin reaction.
Label Elements
- Signal Words
- None
- Hazard Statement(s)
- Hazard-determining components of labelling:
- pyridine 1-oxide
- propyl 3,4,5-trihydroxybenzoate
- Toxic in contact with skin.
- May cause an allergic skin reaction.
- Precautionary Statement(s)
- Avoid breathing dust/fumes/gas/mist/vapours/spray.
- Contaminated work clothing should not be allowed out of the workplace.
- Wear protective gloves/protective clothing.
Primary route(s) of entry
Not available.
Human Health
- Inhalation
- Not available.
- Ingestion
- Not available.
- Eyes
- Not available.
- Skin
- Wash with plenty of water. Call a POISON CENTER/doctor if you feel unwell. Take off immediately all contaminated clothing and wash it before reuse. If skin irritation or rash occurs: Get medical advice/attention.
Environment
- Store locked up.
- Dispose of contents/container in accordance with local/regional/national/international regulations.
3. Composition / Information on Ingredients
| Name | CAS No. | Content (w/w) | Classification |
|---|---|---|---|
| pyridine 1-oxide | 694-59-7 | >25-≤50% | Mixture |
| glycerol | 56-81-5 | >25-≤50% | Mixture |
| propyl 3,4,5-trihydroxybenzoate | 121-79-9 | >2.5-≤10% | Mixture |
4. First Aid Measures
- Ingestion
- If symptoms persist consult doctor.
- Inhalation
- Supply fresh air and to be sure call for a doctor.
- In case of unconsciousness place patient stably in side position for transportation.
- In case of irregular breathing or respiratory arrest provide artificial respiration.
- Skin Contact
- Immediately wash with water and soap and rinse thoroughly.
- Immediately remove any clothing soiled by the product.
- Eye Contact
- Rinse opened eye for several minutes under running water. Then consult a doctor.
- Other Information
- Symptoms of poisoning may even occur after several hours; therefore medical observation for at least 48 hours after the accident.
5. Firefighting Measures
Suitable extinguishing equipment
- Fire
- Use fire extinguishing methods suitable to surrounding conditions.
- HAZCHEM
- No further relevant information available.
Special protective equipment and precautions for fire fighters
Mouth respiratory protective device.
6. Accidental Release Measures
- Personal precautions, protective equipment and emergency procedures
- Not required.
- Environmental precautions
- Dilute with plenty of water.
- Do not allow to enter sewers/surface or ground water.
- Methods and materials for containment and clean up
- Absorb with liquid-binding material (sand, diatomite, acid binders, universal binders, sawdust).
- Dispose contaminated material as waste according to item 13.
- Ensure adequate ventilation.
7. Handling and Storage
- Precautions for safe handling
- Ensure good ventilation/exhaustion at the workplace.
- Prevent formation of aerosols.
- Conditions for safe storage
- Keep container tightly sealed.
8. Exposure Controls / Personal Protection
Exposure Standards
| Material | TWA ppm | TWA mg/m³ | STEL ppm | STEL mg/m³ |
|---|---|---|---|---|
| glycerol | - | - | - | 10mg/m³ |
- Engineering controls
- Keep away from foodstuffs, beverages and feed.
- Immediately remove all soiled and contaminated clothing.
- Wash hands before breaks and at the end of work.
- Store protective clothing separately.
- Avoid contact with the eyes and skin.
Personal protective equipment
- Eye and face protection
- Goggles recommended during refilling.
- Skin protection
- Wear protective gloves. The glove material has to be impermeable and resistant to the product/the substance/the preparation. Selection of the glove material on consideration of the penetration times, rates of diffusion and the degradation. The exact break through time has to be found out by the manufacturer of the protective gloves and has to be observed.
- Body protection
- Not available.
- Respiratory protection
- In case of brief exposure or low pollution use respiratory filter device. In case of intensive or longer exposure use self-contained respiratory protective device.
9. Physical and Chemical Properties
General information
- Appearance
- Colourless liquid
- Odour
- Odourless
- pH
- 7
- Vapour Pressure
- 0.1hPa
- Density
- Not determined.
- Boiling Point
- 270°C
- Melting Point
- Undetermined
- Solubility
- Fully miscible
- Specific Gravity of Density
- Not determined.
- Flash Point
- 160°C
- Flammable (Explosive) Limits
- Not determined.
- Ignition Temperature
- 400°C
- Formula
- Not available.
10. Stability and Reactivity
- Reactivity
- No further relevant information available.
- Chemical stability
- No decomposition if used according to specifications.
- Possibility of hazardous reactions
- No dangerous reactions known.
- Conditions to avoid
- No further relevant information available.
- Incompatible materials
- No further relevant information available.
11. Toxicological Information
- Acute effects
- Not available.
- Eye contact
- No irritating effect.
- Skin contact
- No irritant effect. Sensitisation possible through skin contact.
- Ingestion
- Not available.
- Inhalation
- Not available.
- Toxicity and irritation
- Toxic
- Harmful
- Irritant
12. Ecological Information
- Ecotoxicity
- No further relevant information available.
- Persistence and degradability
- No further relevant information available.
- Bioaccumulative potential
- No further relevant information available.
- Other adverse effects
- Water hazard class 2: hazardous for water.
- Do not allow product to reach ground water, water course or sewage system.
- Danger to drinking water if even small quantities leak into the ground.
13. Disposal Considerations
General information
- Must not be disposed together with household garbage. Do not allow product to reach sewage system.
- Disposal must be made according to official regulations.
- Recommended cleansing agents: Water, if necessary together with cleansing agents.
14. Transport Information
ADG label required
- HAZCHEM
- No further relevant information available.
- UN Number
- Not applicable.
- Proper shipping name
- Not applicable.
- Transport hazard class
- Not applicable.
- Packing group
- Not applicable.
- Environmental hazard
- Not applicable.
- Special precautions for users
- Not applicable.
- Additional information
- Not regulated.
15. Regulatory Information
- Poisons Schedule Number
- None of the ingredients is listed.
- Other Information
- A Chemical Safety Assessment has not been carried out.
16. Other Information
- SDS preparation date
- 27 November 2024
- Comments
- This information is based on our present knowledge. However, this shall not constitute a guarantee for any specific product features and shall not establish a legally valid contractual relationship.