Safety Data Sheets / Citifluor AF4 Antifadent Solution
Safety Data Sheet
Citifluor AF4 Antifadent Solution
1. Identification
Product Identifiers
- Product Name
- Citifluor AF4 Antifadent Solution
- Other Names
- Not available.
- Product Number(s)
- 17973-25, EMS17973-25
- CAS Number
- Not available.
Recommended use of the chemical and restriction on use
Laboratory chemicals.
Company Details
ProSciTech Pty Ltd
11 Carlton Street
KIRWAN QLD 4817
Australia
(07) 4773 9444
pst@proscitech.com
proscitech.com.au
11 Carlton Street
KIRWAN QLD 4817
Australia
(07) 4773 9444
pst@proscitech.com
proscitech.com.au
Emergency Contact Details
ProSciTech Pty Ltd
11 Carlton Street
KIRWAN QLD 4817
Australia
(07) 4773 9444
pst@proscitech.com
proscitech.com.au
11 Carlton Street
KIRWAN QLD 4817
Australia
(07) 4773 9444
pst@proscitech.com
proscitech.com.au
2. Hazards Identification
Classification of the substance or mixture
- GHS07
- Acute Toxicity - Oral 4 H302 Harmful if swallowed.
- Sensitization - Skin 1 H317 May cause an allergic skin reaction.
Label Elements

- Signal Words
- Warning
- Hazard Statement(s)
- Hazard-determining components of labelling: propyl 3, 4, 5-trihydroxybenzoate
- Harmful if swallowed.
- May cause an allergic skin reaction.
- Precautionary Statement(s)
- Avoid breathing dust/fumes/gas/mist/vapours/spray.
- Wash thoroughly after handling.
- Do not eat, drink or smoke when using this product.
- Contaminated work clothing must not be allowed out of the workplace.
- Wear protective gloves.
Primary route(s) of entry
Not available.
Human Health
- Inhalation
- Not available.
- Ingestion
- Call a poison centre/doctor if you feel unwell. Rinse mouth.
- Eyes
- Not available.
- Skin
- Wash with plenty of water. If skin irritation or rash occurs: Get medical advice/attention. Wash contaminated clothing before reuse.
Environment
Dispose contents/container in accordance with local/regional/national/international regulations.
3. Composition / Information on Ingredients
| Name | CAS No. | Content (w/w) | Classification |
|---|---|---|---|
| glycerol | 56-81-5 | >50-≤100% | Mixtures |
| propyl 3, 4, 5-trihydroxybenzoate | 121-79-9 | >2.5-≤10% | Mixtures |
4. First Aid Measures
- Ingestion
- Immediately call a doctor.
- Inhalation
- Supply fresh air and to be sure call for a doctor.
- In case of unconsciousness place patient stably in side position for transportation.
- Skin Contact
- Immediately wash with water and soap and rinse thoroughly.
- Eye Contact
- Rinse opened eye for several minutes under running water.
- Other Information
- Symptoms of poisoning may even occur after several hours; therefore medical observations for at least 48 hours after the accident.
5. Firefighting Measures
Suitable extinguishing equipment
- Fire
- Use fire fighting measures that suit the environment.
- HAZCHEM
- No further relevant information available.
Special protective equipment and precautions for fire fighters
No special measures required.
6. Accidental Release Measures
- Personal precautions, protective equipment and emergency procedures
- Not required.
- Environmental precautions
- Do not allow to enter sewers/surface or ground water.
- Methods and materials for containment and clean up
- Absorb with liquid-binding material (sand, diatomite, acid binders, universal binders, sawdust).
- Dispose contaminated material as waste according to item 13.
- Ensure adequate ventilation.
7. Handling and Storage
- Precautions for safe handling
- Ensure good ventilation/exhaustion at the workplace.
- Prevent formation of aerosols.
- Conditions for safe storage
- No special requirements.
8. Exposure Controls / Personal Protection
Exposure Standards
| Material | TWA ppm | TWA mg/m³ | STEL ppm | STEL mg/m³ |
|---|---|---|---|---|
| glycerol | - | - | - |
- Engineering controls
- Keep away from foodstuffs, beverages and feed.
- Immediately remove all soiled and contaminated clothing.
- Wash hands before breaks and at the end of work.
Personal protective equipment
- Eye and face protection
- Goggles recommended during refilling.
- Skin protection
- Wear protective gloves. The glove material has to be impermeable and resistant to the product/the substance/the preparation. Selection of the glove material on consideration of the penetration times, rates of diffusion and the degradation. The exact break through time has to be found out by the manufacturer of the protective gloves and has to be observed.
- Body protection
- Not required.
- Respiratory protection
- In case of brief exposure or low pollution use respiratory filter device. In case of intensive or longer exposure use respiratory protective device that is independent of circulating air.
9. Physical and Chemical Properties
General information
- Appearance
- Colourless liquid
- Odour
- Characteristic
- pH
- Not determined.
- Vapour Pressure
- <0.1hPa
- Density
- 1.222g/cm³
- Boiling Point
- 290°C
- Melting Point
- 18.2°C
- Solubility
- Not miscible or difficult to mix.
- Specific Gravity of Density
- Not available.
- Flash Point
- 160°C
- Flammable (Explosive) Limits
- Not determined.
- Ignition Temperature
- 400°C
- Formula
- Not available.
10. Stability and Reactivity
- Reactivity
- No further relevant information available.
- Chemical stability
- No decomposition if used according to specifications.
- Possibility of hazardous reactions
- No dangerous reactions known.
- Conditions to avoid
- No further relevant information available.
- Incompatible materials
- No further relevant information available.
11. Toxicological Information
- Acute effects
- 121-79-9 propyl 3,4 5-trihydroxybenzoate
- Oral LD50 2100mg/kg
- Eye contact
- No irritating effect.
- Skin contact
- No irritating effect. Sensitization possible through skin contact.
- Ingestion
- Not available.
- Inhalation
- Not available.
- Toxicity and irritation
- Harmful
- Irritant
12. Ecological Information
- Ecotoxicity
- No further relevant information available.
- Persistence and degradability
- No further relevant information available.
- Bioaccumulative potential
- No further relevant information available.
- Other adverse effects
- Water hazard class 2: hazardous for water.
- Do not allow product to reach ground water, water course or sewage system.
- Danger to drinking water if even small quantities leak into the ground.
13. Disposal Considerations
General information
- Must not be disposed of together with household garbage. Do not allow product to reach sewage system.
- Disposal must be made according to official regulations.
14. Transport Information
ADG label required
- HAZCHEM
- No further relevant information available.
- UN Number
- Void
- Proper shipping name
- Void.
- Transport hazard class
- Void.
- Packing group
- Void.
- Environmental hazard
- Not applicable.
- Special precautions for users
- Not applicable.
- Additional information
- Not available.
15. Regulatory Information
- Poisons Schedule Number
- None of the ingredients is listed.
- Other Information
- A Chemical Safety Assessment has not been carried out.
16. Other Information
- SDS preparation date
- 27 November 2024
- Comments
- This information is based on our present knowledge. However, this shall not constitute a guarantee for any specific product features and shall not establish a legally valid contractual relationship.
